United Pacific Chrome Projection Headlight LED Turn Signal Position Light Kenworth T660 Driver 32779

Chrome Projection Headlight For Kenworth T660

This chrome projection headlight fits all Kenworth T660 models from 2008 onward and is sold individually for the driver side. It integrates LED turn signal and LED position light functions into a single modular headlight assembly. The unit carries DOT/SAE approval and meets FMVSS 571 requirements for on-road use. It is intended for fleets or owner-operators replacing a damaged or outdated factory headlight on a compatible truck.

Electrical Limits And Compliance Standards

Low beam draws 4.1 amps at 12 volts for 49.2 watts, while high beam draws 5.1 amps at 12 volts for 61.2 watts, both certified to FMVSS 571. Parking lamps operate at .14 amp and the turn signal circuit totals .22 amp with each LED rated at .3 watts. The DOT/SAE approval confirms the optical pattern satisfies federal visibility and glare standards. No other voltage or wattage ratings are specified for this assembly.

Verify Fitment And Electrical Compatibility

Confirm the vehicle is a Kenworth T660 built in 2008 or later and that the driver-side housing is the one requiring replacement. The headlight is sold individually, so the passenger-side unit must be ordered separately if needed. Ensure the truck's 12-volt system can supply the stated amperage for low beam, high beam, parking and turn signal circuits. Check that the existing wiring connectors match the modular headlight interface before installation.