Unity 11425 Front Left Strut Assembly BMW X5 X6 2007-2014

Direct-Fit Strut Assembly for BMW X5 and X6

The Unity 11425 is a complete front-left strut assembly engineered to match original equipment specifications for 2007 to 2013 BMW X5 and 2008 to 2014 BMW X6 models. It arrives fully preassembled with a new gas-charged shock cartridge, coil spring, top mount, bearing plate, bump stop, insulators and dust boot. This design restores factory ride height and handling without the need for separate component assembly or spring compression tools. It is sold individually for targeted corner replacement.

Consistent Damping Over Extended Use

The gas-charged shock cartridge maintains stable damping force during prolonged driving by reducing oil aeration that can cause fade in conventional units. Because every internal component is new, the assembly delivers repeatable rebound and compression control across varying road surfaces and load conditions. The integrated coil spring works in harmony with the damper to preserve ride quality over the vehicle's service interval. Replacing both front struts together ensures balanced performance side to side.

Bolt-On Build With Factory Mounting Points

The unit weighs 19 lbs and measures 25 by 9 by 9 inches, matching the original mounting geometry for a direct bolt-on installation. All-new top mounts, bearing plates and isolators eliminate worn bushings that transmit noise and vibration into the chassis. The preassembled construction removes the safety risk and specialised tooling normally required for spring compression. Rubber dust boots protect the polished shock shaft from road debris and moisture ingress.

Installation Ready Without Specialty Tools

The complete assembly arrives ready to install, eliminating the need for a spring compressor or separate component assembly. New upper and lower spring isolators, bearing plate and top mount are already fitted to the coil spring and gas-charged cartridge. This reduces shop time and removes the safety hazard of handling compressed springs. The direct-fit design aligns with factory mounting points on the specified BMW models. It is not a universal part and will not fit vehicles outside the listed application range.