Usa Sealing PVC fuel tubing 1/8 in ID 1/4 in OD 10 ft yellow
PVC tubing carries fuel, lubricant or water at up to 20 psi and 140 °F
- Product colorYellow
- Handles fuels, lubricants and water with one PVC line
- Shore A 60 hardness resists hardening and swelling over time
- 20 psi rating and 140 °F limit suit low-pressure systems
- 10 ft coil of 1/8 in ID and 1/4 in OD for flexible routing
- Yellow colour aids quick visual identification in busy engine bays
Fuel line for small-engine plumbing
This yellow PVC tubing handles fuels, lubricants and water in automotive and small-engine systems. The 10 ft length with a 1/8 in inside diameter and 1/4 in outside diameter suits gravity-feed and low-pressure circuits. It is peristaltic-pump compatible for metered dispensing.
Slips onto barbed fittings without clamps in many
Shore A 60 hardness keeps the bore from collapsing on tight bends while remaining flexible enough to route around engine components. The material resists hardening and swelling so the seal stays reliable after repeated heat cycles. No jacket means direct contact with the fluid path.
Rated for continuous use at 20 psi
Pressure and temperature limits are maximums, not burst ratings, so the tube maintains dimensions during long idling or recirculation runs. California Proposition 65 notices apply to this product.
How it compares
Measured against everything we stock in Drain Stoppers, Strainers & Traps, at today’s prices. Recalculated every night.
- Price $4.99
- Cheaper than about 93% of the 4,240 comparable items (median $31.99).
Specifications
| Product | |
|---|---|
| Brand name | ZORO SELECT |
| Product color | Yellow |
Questions about this item
Will the 20 psi pressure limit hold up during long fuel-line runs?
The tubing is rated for a maximum operating pressure of 20 psi, so sustained use must stay at or below that figure.
Does the PVC stay flexible and cool when fuel flows all day?
Rated to 140 °F with hardening- and swelling-resistant PVC, it resists heat-related stiffening during continuous operation.
What fittings do I need to connect the 1/8 in ID and 1/4 in OD ends?
Use barbed or compression fittings sized for 1/8 inch inside diameter and 1/4 inch outside diameter to match the tubing dimensions.
More in Drain Stoppers, Strainers & Traps
Similar items
Nibco, Inc. 600DS 1-1/2" Copper Dimple Stop Coupling
- Drain Components
- HAWA
Banjo RB300-150 3 inch MNPT x 1-1/2 inch FNPT Reducing Bushing Schedule 80 trap
Banjo 100E 1" Male Adapter x Hose Shank Cam Lever Coupling Trap
- Drain Components
- HAWA





