USBGear USBG-AA9CC USB 2.0 A-to-A extension cable 9ft smoke

Connection type and reach

The USBGear USBG-AA9CC is a nine-foot USB 2.0 A-to-A extension cable in a smoke-coloured jacket. It adds length to the flat Type A end of an existing cable so that printers, scanners, modems, cameras or similar peripherals can sit further from the host computer. Foil-and-braid shielding plus 24-gauge power conductors and 28-gauge data pairs are designed to preserve signal integrity at the full 480 Mbits per second rate. Molded strain relief and PVC over-moulding protect the terminations from repeated flexing.

Who this suits and who it does not

The cable suits anyone who needs to bridge a gap of up to nine feet between a standard USB A port and a USB A device without introducing a hub. It is not for connections that require USB 3.0 or higher throughput, nor for linking two host controllers directly. Builders who need a longer single run than the USB 2.0 specification allows should look at active repeater or fibre solutions instead.

Behaviour under sustained load

Shielding and the specified wire gauges aim to keep error rates low during continuous bulk-endpoint transfers such as long print jobs or scanner sweeps. The USB 2.0 standard caps a passive cable at about 16.5 feet, so this nine-foot length stays within the passive limit and avoids the signal degradation that longer unamplified runs can exhibit. Temperature rating of 80 °C and VW-1 flammability compliance indicate the materials tolerate warm operating environments without softening.