UTEK D06K-24TU 45B 60x60x25mm DC24V 0.10A 3-line case fan
A 60 mm DC 24 V case fan with a locked-rotor sensor, 4150 RPM speed, 21.19 CFM airflow and 31 dBA noise
- Product typeAccessories
- Quiet operation at 31 dBA noise level
- Moves 21.19 CFM of air for effective cooling
- Runs on standard DC 24V power supply
- Low 1.92W power draw saves energy
- Locked rotor sensor protects against stall
Compact 60 mm 24 V case fan
The UTEK D06K-24TU 45B is a 60 × 60 × 25 mm DC fan rated for 24 V operation with a maximum current draw of 0.10 A. It spins at 4150 RPM to deliver 21.19 CFM of airflow while producing 31 dBA of noise. A three-wire connection provides a locked-rotor sensor signal for monitoring.
Suited for tight 24 V cooling spots
This fan fits builders who need a low-profile 60 mm frame powered from a 24 V rail in industrial enclosures, embedded boards or small-form-factor chassis. The sleeve bearing and modest airflow make it a match for light heat loads where space is at a premium. Buyers who need higher static pressure, PWM speed control or a larger frame should look elsewhere.
21.19 CFM at 4150 RPM with 31 dBA
At full speed the fan moves 21.19 CFM, which is adequate for spot-cooling voltage regulators, compact power supplies or single-board computers in a 60 mm cut-out. The 1.92 W input power leaves little headroom for dense fin stacks or restrictive filters; airflow will drop sharply when the fan faces significant back-pressure. The locked-rotor sensor alerts the host if the rotor stalls, but there is no PWM input for dynamic speed scaling.
How it compares
Measured against everything we stock in PC Cooling Fans, at today’s prices. Recalculated every night.
- Price $17.99
- Cheaper than about 57% of the 8,339 comparable items (median $19.99).
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
| Product | |
|---|---|
| Product type | Accessories |
Questions about this item
Does my system need a 24 V DC header to run this fan?
Yes, the fan requires a DC 24 V supply and draws 0.08 A typical with a 0.10 A maximum.
Can I plug the 3-pin connector into an older 3-pin motherboard header?
The 3-pin connector fits standard 3-pin headers, but the header must supply 24 V DC or the fan will not spin.
How can I confirm the fan is running at its rated speed after installation?
Monitor the tachometer signal on the third wire; it should report 4150 RPM when the fan receives full 24 V power.
More in PC Cooling Fans
Similar items
be quiet! Light Wings 140mm PWM ARGB Case Fan Black BL074
- 1 Fan
- No Controller
Phanteks PH-F140M25R_G2_DBK01_3P 140mm case fan 3-pack
- 3 Fans
- No Controller
Lian Li 14RSLIN1B 140 mm case fan, black, ARGB, 1600 rpm, 72.7 CFM, 28 dBA
- 140 mm
- 1 Fan
Noctua NF-A6x25 FLX 60mm 25mm 3-pin case fan
- 1 Fan
- No Controller





