We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Five brass hex head plugs with threaded ends

Value Brand

Value Brand Hex Head Plug Brass 5 Pack

SKU CH-3SQT-CAJ9J

Five brass hex-head plugs with 3/4-14 threads, rated from -65 to 250 °F

  • Brass construction resists corrosion for long service life
  • Threaded 3/4-14 NPT fits standard pipe fittings
  • Pre-applied sealant speeds installation without extra tape
  • Five-piece pack covers multiple connection points
  • Rated from -65 to 250 °F for wide temperature range

Brass hex head plug pack

This pack contains five brass hex head plugs sized for 3/4-14 threaded connections. They are intended for plumbing professionals and DIY users who need to seal pipe ends or ports in water, gas or hydraulic systems.

Brass construction with pre-applied sealant

Each plug is made from solid brass rated from minus 65 degrees to 250 degrees Fahrenheit. The threads ship without pre-applied sealant or an included seal, so installer-chosen thread tape or compound is required for a leak-free joint.

Check thread size and chemical restrictions

Verify that the 3/4-14 thread matches the port you are closing before ordering. The product carries a California Proposition 65 warning for chemicals known to cause cancer and reproductive harm, which may affect use in certain jurisdictions.

How it compares

Measured against everything we stock in Bath Accessories & Soap Dispensers, at today’s prices. Recalculated every night.

Price $14.99
Cheaper than about 80% of the 1,499 comparable items (median $39.99).

Specifications

Product
Brand nameVALUE BRAND
Product typeOther

Questions about this item

What nominal pipe size and thread standard does the 3/4-14 hex head plug use?

The plug follows a 3/4 inch nominal pipe size with 3/4-14 NPT threads for a tapered seal.

What clearance and wrench size are needed to install the brass hex head?

A six-point socket or open-ended spanner that fits the hex flats is required; allow enough knuckle room to apply torque without damaging surrounding pipework.

How should the threads be prepared before fitting the plug rated to 250 degrees F?

Clean the female threads, apply PTFE tape or pipe dope approved for the temperature range, then tighten the hex head until the joint is leak-free without over-stressing the brass.

More in Bath Accessories & Soap Dispensers

Similar items