VEVOR Garage Door Torsion Springs 0.25 x 2 x 30 inch Pair 16000 Cycles Specialty Appliance

Garage Door Torsion Spring Pair

This set contains two torsion springs sized 0.25 inch wire diameter by 2 inch inner diameter by 30 inch length. One spring is dextrorotary and the other levorotary for balanced operation. They are built from high carbon steel 82B with cast aluminum ADC12 cones and an electrocoating finish. The kit includes two winding bars, a mounting wrench and a pair of non-slip gloves.

Suited for Standard Residential Replacement

These springs suit homeowners replacing a matching pair on a standard sectional garage door where the original specs are identical. Each spring is rated for approximately 16000 cycles of opening and closing. Buyers who need a different wire diameter, inner diameter or coil length should look elsewhere because the dimensions must match exactly for safe installation.

Sustained Load Behaviour

The electrocoated surface resists corrosion and wear without extra lubrication, helping the springs maintain elasticity over years of daily cycling. Heat-treated coils and aluminum cones distribute stress evenly across the 120 coils during repeated winding and unwinding. The rated 16000 cycles reflect long-term durability under normal residential use rather than a short-term burst test.