VEVOR Garage Door Torsion Springs Pair 0.207 x 2 x 24 in 16000 Cycles

Garage Door Torsion Springs Pair

This pair of torsion springs is designed as a direct replacement for residential garage doors that require a 0.207-inch wire diameter and 24-inch length. The set includes one left-wound and one right-wound spring to match standard dual-spring configurations. It is intended for homeowners or technicians performing a like-for-like swap on existing hardware.

16000-Cycle Service Life Capacity

Each spring is rated for approximately 16000 open-and-close cycles, which translates to several years of typical daily use before fatigue becomes a concern. The heat-treated high-carbon steel coils with cast aluminum cones maintain elasticity over that span. The electrocoated black finish provides corrosion and wear resistance without the need for additional lubrication, though the springs will eventually reach their cycle limit and require replacement.

Direct Replacement Fit Requirements

The springs measure 0.207 x 2 x 24 inches with 116 coils and a 24.3-inch overall length, so the existing door hardware must match these exact dimensions for proper fit. The package supplies winding bars, non-slip gloves and a mounting wrench to assist installation, but the door must already have compatible anchor brackets and a solid shaft. Doors using a different wire diameter, inner diameter or coil count are not suitable for this kit.