Viega MegaPress 45 street elbow 1/2" 95080
Stainless-steel 45-degree press-fit street elbow joins 1/2 in pipe to a 1/2 in fitting at up to 200 psi
- Main materialHAWA
- Press-fit connection speeds installation without threading
- 45-degree street elbow redirects flow in tight spaces
- 304 stainless steel body resists corrosion in non-potable systems
- FKM O-ring seals reliably up to 200 psi operating pressure
- 1/2 inch press-to-FTG sizing fits standard copper tube dimensions
Viega MegaPress 45° Street Elbow
The Viega MegaPress 45° street elbow joins two half-inch stainless-steel pipes at a forty-five-degree angle using a press-fit connection on one end and a fitting connection on the other. It is built for non-potable water systems where corrosion resistance and a secure mechanical joint are required.
Sustained-pressure performance
The fitting is rated for a maximum operating pressure of 200 psi, so it maintains its seal continuously under normal system pressure without relying on a short-term burst rating. Grade 304 stainless steel and an FKM O-ring resist degradation from temperature cycles and chemical exposure over long service intervals.
Press-fit interface limits
The press-fit end requires a compatible press tool and jaw set to form a permanent joint; it cannot be disassembled or reused once crimped. The fitting end accepts a half-inch copper tube stub, so the installer must ensure the mating tube meets the correct outside diameter and wall thickness for a leak-free fit.
How it compares
Measured against everything we stock in Plumbing Valves & Valve Assemblies, at today’s prices. Recalculated every night.
- Price $50.99
- Typical for this category: the median of 720 items is $47.49.
Specifications
| Product | |
|---|---|
| Brand name | Viega |
| Size & build | |
| Main material | HAWA |
Questions about this item
Does the FKM O-ring on the 95080 handle continuous 200 psi pressure without heat-related degradation?
The FKM O-ring material is rated for the fitting's maximum operating pressure of 200 psi in non-potable water applications.
Which press tool and jaw profile are required to install the 1/2" press-fit end on the 95080?
A compatible press tool with the correct jaw profile for 1/2" stainless steel press-fit connections is needed.
Can the 304 stainless steel street elbow join directly to older copper pipe of the same 1/2" size?
The FTG end accepts 1/2" copper tube size, allowing direct connection to existing copper piping.
More in Plumbing Valves & Valve Assemblies
