We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Bronze tee fitting with three press connections

Viega

Viega ProPress 2917.2 Bronze Tee 1" x 1" x 1/2

SKU CH-H3KB-AXZX0

Bronze press-fit tee joins two 1" copper lines and a 1/2" FNPT branch for potable water at 200 psi

  • Press-fit ends join copper tube without soldering
  • Bronze body resists corrosion in potable water systems
  • EPDM O-ring seals at 200 psi working pressure
  • 1/2 in FNPT branch adapts to threaded components
  • Center-stop dimple ensures correct insertion depth

Bronze tee for potable water systems

This Viega ProPress 2917.2 bronze tee connects two 1 in press-fit copper tubes and a 1/2 in FNPT branch for potable water applications. The EPDM O-ring and centre-stop dimple ensure a secure, leak-free seal at up to 200 psi operating pressure. It is designed for installers who need a reliable transition between press-fit mains and threaded outlets.

Replaces threaded or soldered tees

The press-fit ends eliminate the need for open-flame soldering or pipe-thread cutting on the main run, reducing installation time and fire-risk on site. The jump is worth it when a project demands faster joint completion, consistent seal quality, or compliance with no-burn permit requirements. It is not suited for systems that require all-threaded connections or non-potable fluid service.

Installs with standard press tool

A compatible press tool and 1 in jaw set complete the two press connections in seconds, while the 1/2 in FNPT branch accepts standard pipe thread sealant and a wrench. Common issues include using an incorrect jaw size, skipping the centre-stop check, or over-tightening the threaded branch, which can distort the bronze body. Always verify the dimple is seated before pressurising.

How it compares

Measured against everything we stock in Hose Fittings, Adapters & Clamps, at today’s prices. Recalculated every night.

Price $27.99
Pricier than about 66% of the 2,955 comparable items (median $17.99).

Specifications

Product
Brand nameViega

Questions about this item

What copper tube sizes does the 2917.2 tee accept on each port?

The tee has press-fit ends for 1 in copper tube on the run and a 1/2 in FNPT branch for threaded connection.

Which press tool and jaw size are required to install the 1 in press ends?

Use a Viega ProPress tool with the 1 in jaw; the common error is pressing before the tube is fully seated past the stop dimple.

When should the EPDM O-rings on the press ends be inspected or replaced?

Inspect the O-rings during any system pressure test; replace them if they show cracking, flattening or if the joint is disassembled.

More in Hose Fittings, Adapters & Clamps

Similar items