Ubiquiti Networks NSM5(US) 5.0 GHz network antenna
- 2 × 10/100 Ethernet…
- 5.0 GHz
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Two 10 ft RP-SMA male-to-female coaxial cables extend Wi-Fi antennas for optimal 2.4 GHz placement with 50 ohm low-loss wire
Two RP-SMA male-to-female coaxial cables extend antenna placement by three metres each. The 50 ohm RG174-type wire is built for wireless LAN, cellular and similar RF gear rather than broadcast TV. Each cable uses pure copper connectors with oxidised finish for reliable contact. The pair suits routers, bridges, desktop antennas and network adaptors needing remote antenna positioning.
The dedicated 50 ohm engineering wire keeps attenuation minimal across the entire ten-foot run. Signal integrity remains consistent whether the link operates in the 2.4 GHz band or other supported wireless LAN frequencies. Connectors are rated for repeated mating cycles without measurable degradation. The construction avoids the high loss typical of generic thin coax when run at full extension.
The cables are specified for IEEE 802.11a, b, g and n wireless LAN standards and 24 dBi antenna configurations. They do not support television or broadcast antenna interfaces. Maximum usable frequency is defined by the listed wireless LAN standards rather than broader microwave ranges. Users requiring connections beyond these protocols or for TV distribution should select a different cable type.
Measured against everything we stock in Wi-Fi Antennas & Wireless Bridges, at today’s prices. Recalculated every night.
| Product | |
|---|---|
| Brand name | CORONIR |
| Model name | RG1745012 |
| Part number | RG1745012 |
| Product color | Black |
The RG174 50 ohm wire is built for low loss on wireless LAN links, so a 10ft run keeps attenuation minimal during continuous use.
You need a device or antenna with an RP-SMA female port and a matching RP-SMA male antenna or pigtail to complete the link.
Yes, the cable is compliant with IEEE 802.11b/g/n networks and matches the 50 ohm impedance used by typical 2.4 GHz high-gain antennas.
More in Wi-Fi Antennas & Wireless Bridges
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?