Westward 2AJG3 Roll Pin Punch 1/4 in Tip 6 7/16 in Length

Roll Pin Punch 1/4 in Tip

The Westward 2AJG3 is a hand-held roll pin punch built for technicians who drive or remove spring and roll pins in automotive and machinery assemblies. Its 1/4 in tip matches standard pin diameters, while the 6 7/16 in overall length gives sufficient reach into recessed holes. Chrome vanadium steel with a black oxide finish resists wear and corrosion during repeated impact use. The one-piece design eliminates loose components that could be lost in the workshop.

Mechanics needing a single-size punch

This tool suits professionals and hobbyists who regularly service the same pin diameter and want a dedicated, tether-capable punch that meets safety-drop requirements. Buyers who need multiple tip sizes for varied fastener diameters should look at a punch set instead. The fixed 1/4 in tip cannot accommodate larger or smaller pins, so workshops handling mixed hardware will require additional sizes. California Proposition 65 warnings apply to the materials used in this punch.

1/4 in tip diameter decides fit

The 1/4 in tip is the critical dimension that determines whether this punch matches the roll or spring pins in your application. Verify the pin diameter before purchase, as an oversized or undersized tip will damage both the pin and the surrounding component. No other specification overrides this fit requirement for successful pin installation or removal.