Westward 4BY84 Hose Extension 12 in
A 12‑inch polyurethane hose extension with 1/8 MNPT ends, 3,500 psi rating and plated‑steel crimped couplers
- Product colorTransparent
- 12-inch length reaches tight drain spaces easily
- Transparent polyurethane shows blockages instantly
- 3,500 psi rating handles high-pressure cleaning jobs
- Plated steel ends with hydraulic crimping prevent leaks
- 1/8 MNPT connections fit standard plumbing fittings
12 in Hose Extension
The Westward 4BY84 is a 12 inch polyurethane hose extension with 1/8 MNPT male connections on both ends. It is rated for a maximum pressure of 3,500 psi and features plated steel ends secured by hydraulic crimping. A coupler is included with the hose. This product is intended for users who need a short, high-pressure hydraulic line extension.
Replaces worn hydraulic lines
This extension replaces a damaged or leaking hose segment in a hydraulic circuit where 1/8 MNPT threads are used. The jump is worth it when the existing hose has cracked, the fittings have corroded, or the assembly length must be increased by 12 inches. The 3,500 psi rating must match or exceed the system operating pressure for safe operation.
Check thread size and chemical warning
Verify that both connection ports on your equipment use 1/8 MNPT threads before ordering. Confirm the system pressure does not exceed 3,500 psi. Be aware this product carries a California Proposition 65 warning for chemicals known to cause cancer and birth defects or other reproductive harm.
How it compares
Measured against everything we stock in Drain Stoppers, Strainers & Traps, at today’s prices. Recalculated every night.
- Price $5.99
- Cheaper than about 92% of the 4,240 comparable items (median $31.99).
Specifications
| Product | |
|---|---|
| Brand name | WESTWARD |
| Product color | Transparent |
Questions about this item
What thread size does the 12 in extension use to connect?
The hose extension has 1/8 MNPT male threads on both ends for direct connection to compatible fittings.
How do I install the extension without damaging the crimped ends?
Thread each 1/8 MNPT end by hand until snug, then tighten gently with a wrench on the plated steel hex flats — do not clamp the rubber hose body.
When should I replace the 12 in polyurethane hose extension?
Replace it if the transparent hose shows cracks, bulges, abrasion, or if the plated steel ends leak or corrode under 3,500 psi service.
More in Drain Stoppers, Strainers & Traps
Similar items
Cherne 270237 3 in End-of-Pipe Plug with Wing Nut
- Drain Components
- HAWA
Nomaco Kflex 801-T-048238 Trap 2-3/8" x 59/64
- Drain Components
- Black
Banjo HB150/125-90 1-1/4" Barbed x 1-1/2" MNPT 90° Elbow Trap
- Drain Components
- Black





