We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black plastic BL cable extension bracket with 1.5M cable for CR10 and Ender-3 printers

YINGHUA

YINGHUA BL Connection Cable Extension Bracket 1.5M 3D Printer Accessory

SKU CH-EVVQ-753DS

Extends the BL auto-leveling cable by 1.5 metres for CR-10 and Ender-3 printers

  • Achieve precise automatic leveling with the BL touch sensor kit
  • 5 metre cable reaches the controller board on large printers
  • Durable plastic bracket resists wear from repeated bed probing
  • Compatible with CR-10 and Ender-3 series machines
  • Plug-and-play design removes the need for manual bed calibration

BL Touch Cable Extension for CR-10 and Ender-3

This 1.5 metre extension cable connects a BL Touch sensor to the mainboard on Creality CR-10 and Ender-3 printers. It replaces the stock cable when the sensor is mounted further from the board or routed through a cable chain. The part is intended for owners adding or relocating automatic bed levelling on these machines.

Plastic housing with pre-fitted connectors

The cable uses a plastic sheath and moulded plugs that slot directly into the BL Touch probe and the printer mainboard without soldering. The 1.5 metre length gives enough slack for full gantry travel on the target printers while keeping the routing tidy. The durable plastic construction resists fatigue from repeated motion during long prints.

Replaces the short factory cable on stock BL Touch

The upgrade is worthwhile when the original cable is too short for a relocated sensor, a direct-drive conversion or a custom enclosure. It is not for printers that use a different probe connector pinout or for users who need a shorter run to avoid excess cable drag.

How it compares

Measured against everything we stock in 3D Printing Accessories & Materials, at today’s prices. Recalculated every night.

Price $13.99
Cheaper than about 85% of the 592 comparable items (median $31.99).

Specifications

No published specifications for this item yet.

Questions about this item

What does the 1.5 m BL cable length allow on a CR-10 or Ender-3?

The 1.5 m cable reaches from the BLTouch probe to the mainboard on standard CR-10 and Ender-3 frames without stretching or needing an extra extension.

What mounting hardware does the bracket need to fit the printer?

The plastic bracket uses the existing M3 holes on the print-head carriage; no new holes or adapters are required.

How is the BL cable connected, and what step is often missed?

Plug the 3-pin connector into the BLTouch port on the mainboard and the 2-pin end into the probe; the step many forget is flashing firmware with BLTouch enabled before the first print.

More in 3D Printing Accessories & Materials

Similar items