30 Pcs Extension Cord Replacement Ends Male Female 125v 15a 2 Pole 3 Wire 16/18 AWG Wire Cap Connectors

Replacement Plug Kit Contents

The pack supplies 30 pieces split evenly between male and female ends giving 15 of each type for repairing damaged cords or building custom leads. Each unit is rated for 125 volts and 15 amps with a NEMA 5-15 2‑pole 3‑wire grounding configuration. The connectors accept 16 or 18 AWG conductors making them suitable for common household and light‑duty tool cables. They are intended for indoor use where a straight blade plug is required.

Build Quality and Assembly

The housings are moulded from impact‑resistant plastic that shields the contact points from dust and helps prevent conductors from pulling loose. A hinged body allows the two halves to open and close quickly so a worn plug can be swapped in a few minutes without special tools. The straight blade layout matches standard North American outlets and the 3‑prong design maintains the ground path through the repair.

Electrical Limits and Heat

Rated at 1875 watts the parts must not carry more than 15 amps in normal service. The plastic body and internal contacts are sized for that load so temperature rise stays low during typical appliance or tool operation. No active cooling is involved and the connectors run silently. Exceeding the stated current can cause overheating so the repair should only be used on circuits protected by a 15 amp breaker or fuse.