PYLE AUDIO PLMRCW3 marine electronic 9.18 x 4 x .5 white
- 4 in × 9.18 in × 0.…
- Accessories
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Waterproof 5.25-inch two-way marine speakers with blue LEDs, 180 W max power and 0.92-inch mounting depth
This 5.25 inch two-way speaker pair delivers 180 watt maximum power for boats and off-road vehicles. The waterproof construction withstands heavy splashes and outdoor conditions while providing full-range stereo sound. Blue LED illumination adds visibility during evening trips. The 4 ohm impedance matches common marine amplifiers.
Each speaker carries an IP-rated waterproof seal and a low-profile white grille that resists UV exposure. The 6.4 inch total diameter fits factory cut-outs while the 0.92 inch mounting depth clears tight bulkheads. A 9.8 foot wiring harness reaches helm consoles without splicing. The 80 Hz to 18 kHz frequency response covers vocals and instruments clearly.
Replaces single-cone OEM units that lack weather sealing and adequate output. The two-way design separates bass and treble for cleaner dialogue and music at cruising speed. The jump is worth it when the original speakers distort at volume or fail after a season of spray exposure. Buyers needing a subwoofer channel or multi-zone amplification should look elsewhere.
Measured against everything we stock in Boat Audio & Electronics, at today’s prices. Recalculated every night.
| Product | |
|---|---|
| Brand name | Pyle |
| Audio & video | |
| Speaker unit size | 5.25 in (13.3 cm) |
The pair presents a 4 ohms impedance and a frequency response of 80 Hz to 18 kHz, so your amplifier must be stable at that load and the usable bass rolls off below 80 Hz.
Each speaker needs a 6.4 inch cut-out and only 0.92 inch of mounting depth, so measure the available cavity behind the panel before drilling.
Connect the positive and negative wires from each speaker to the corresponding amplifier channels, observing polarity, and route the cable away from engine noise sources to avoid interference.
More in Boat Audio & Electronics
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?