Ashcroft G17M0242EW3000# Pressure Transducer 0-3000 psi
Pressure transducer measures 0 to 3000 psi with 4 to 20mA output and ±0.50% accuracy
- Measures 0 to 3000 psi with +/- 0.50% accuracy
- 4 to 20mA output on 9 to 36V DC power
- NEMA 4X and IP67 rated for harsh environments
- Operates from -40 to 257 degrees F
- 1/4 in male NPT with 4-pin M12 connector
Ashcroft G2 Series 0–3000 psi Transducer
The Ashcroft G2 pressure transducer measures 0 to 3000 psi with a 4–20 mA two-wire output. It connects through a 4-pin M12 plug and a 1/4 in male NPT process port. The unit suits hydraulic, pneumatic and industrial monitoring tasks that demand a compact stainless-steel sensor.
Sustained-load stability and environmental rating
Accuracy holds at ±0.50 % of full scale across the -40 °F to 257 °F operating range. The NEMA 4X and IP67 sealed housing resists wash-down, corrosion and temporary immersion. Power input accepts 9 to 36 V DC, so voltage drops on long cable runs do not shift the signal.
Pre-installation checks for your system
Verify that the 1/4 in male NPT thread matches the port on your manifold or pipe fitting. Confirm the control system reads a 4–20 mA current loop and supplies 9–36 V DC to the transmitter. Ensure the 1/2 in FNPT conduit entry or M12 cable route fits the enclosure layout and that the ambient temperature stays within the rated limits.
How it compares
Measured against everything we stock in Pressure Washer Guns & Spare Parts, at today’s prices. Recalculated every night.
- Price $113.99
- Pricier than about 78% of the 141 comparable items (median $26.99).
Specifications
| Product | |
|---|---|
| Brand name | ASHCROFT |
Questions about this item
Does the G2 transducer generate noticeable heat or draw much power when running continuously at 3000 psi?
The unit operates on 9 to 36V DC with a 4 to 20mA DC output loop, so power draw stays low and self-heating is minimal even during all-day use.
What existing wiring and fittings do I need to install this 4-pin M12 transmitter?
You need a 9 to 36V DC supply, a 2-wire 4 to 20mA input on your controller, a 1/4 in male NPT process port, and a 1/2 in FNPT conduit entry for the M12 cable.
Will this NEMA 4X, IP67 sensor connect directly to my older panel meter that expects a 4 to 20mA signal?
Yes — the transducer provides a standard 4 to 20mA DC output over two wires, compatible with legacy panel meters, PLCs or recorders that accept that signal range.
More in Pressure Washer Guns & Spare Parts
Similar items
Uei Test Instruments
Uei Test Instruments EM152 Digital Manometer Differential Backlit LCD ±60 in wc accessory
$112.99
0.0013655BTC
In stock
