AUBEAMTO TJ-A285 10ft DisplayPort 2.0 cable 80Gbps 16K@60Hz

AUBEAMTO TJ-A285 10ft DisplayPort 2.0 cable

This AUBEAMTO TJ-A285 cable carries DisplayPort 2.0 signals over a 10ft run at up to 80Gbps. It suits gamers and creators driving 16K at 60Hz, 8K at 120Hz or 4K at 240Hz from a PC or laptop to a monitor, TV or projector. The male-to-male connectors support G-Sync and FreeSync variable refresh rates. Dynamic HDR 4:4:4 and HDCP 2.2 are included for protected 10-bit colour workflows.

Plug-and-play installation with latch release

Both ends use standard DP 2.0 male plugs that click into any DP 1.2, 1.4 or 2.0 port; press the latch to unplug. The 10ft length reaches wall-mounted displays but adds cable weight — route it so the connectors are not bent sideways. Solid copper conductors and triple-layer shielding keep the 80Gbps link stable, yet sharp kinks or tight zip-ties can still degrade the signal. No driver or firmware step is required; the link trains automatically at the highest common rate.

Check port version and required resolution before

Verify that your source and display both expose DisplayPort 2.0 (UHBR20) ports to reach 16K at 60Hz or 8K at 120Hz; older DP 1.4 ports will fall back to 8K at 60Hz or 4K at 144Hz. Confirm the monitor’s EDID lists the target mode — some 16K panels only accept 30Hz over a single cable. Ensure your GPU drivers are current enough to enumerate UHBR speeds. The cable is backward compatible, but the highest refresh rates need matching 2.0 hardware on both ends.