Klein Tools 85191 Conduit Reaming Screwdriver 5/16 tip 13 19 25 mm
- Card
- * Hooded-blade desi…
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
A 6-digit LED counter with count up, down and up/down modes plus seven timer functions, powered from 100-240VAC at 50/60Hz and IP65 front-panel rated
The Autonics CT6S-2P4T is a panel-mount counter and timer built for industrial control panels. It presents values on a 6-digit 7-segment LED display with red illumination. The unit accepts a 100-240VAC supply at 50/60Hz and connects via a rear terminal block. Its front panel meets IP65 protection for dust and water jets.
This instrument suits engineers wiring count-up, count-down or count-up/down sequences and timer routines such as signal on-delay, power on-delay, flicker, interval, signal off-delay, on-off delay or integration time. It is not for applications that require a serial or network interface, analog output or a display larger than six digits.
The counter operates directly from mains voltage across the full 100-240VAC range at 50 or 60Hz without an external transformer. Verify that the installation provides this supply and that the front-panel IP65 rating satisfies the enclosure sealing requirements.
Measured against everything we stock in Electrical Trade Tools & Kits, at today’s prices. Recalculated every night.
| Product | |
|---|---|
| Brand name | Autonics |
| Model name | CT6S-2P4T |
| Product type | Test Equipment |
| Color and finish | Red |
| In the box | |
| Number of items | 1 pack |
The unit has no fan and uses a low-heat LED display; the IP65-rated front panel is sealed for dust and water jets, so it runs silently with minimal warmth in an enclosure.
You need a panel cut-out for the front-mount housing, screw terminals for the power and signal wires, and a 100-240 VAC 50/60 Hz supply — no special cables or adapters are included.
Yes — the terminal-block inputs accept standard voltage-free or voltage-level signals, and the multiple output modes (ON/OFF delay, flicker, interval, integration) are compatible with typical sensor and relay logic.
More in Electrical Trade Tools & Kits
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?