We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Two green DDR4 DIMM modules with black heat spreaders

Blazing Memory

Blazing Memory BM8GKITD43200DT 8GB DDR4 2x4GB 3200MHz accessory

SKU CH-6FV0-1EPDM

Two matched 4 GB DDR4 DIMMs running at 3200 MHz with 1.2 V unbuffered non-ECC operation

  • 8 GB total capacity from two matched 4 GB modules
  • DDR4 3200 MHz speed for responsive desktop performance
  • 2 V operation keeps power draw low
  • 288-pin DIMM form factor fits standard desktop slots
  • Non-ECC unbuffered design suits mainstream desktop systems

Kit contents and target builder

This kit contains two matched 4 GB DDR4 DIMMs for a total of 8 GB. It is built for desktop systems that accept 288-pin unbuffered non-ECC modules running at up to 3200 MHz.

Suitable systems and mismatched needs

The memory suits desktops requiring PC4-25600 speed and 1.2 V operation. It will not meet the needs of users who want ECC error correction, higher total capacity or laptop SO-DIMM form factors.

Installation ease and common issues

Installation is a standard DIMM insertion into the motherboard slots. The most frequent issue is the system defaulting to the lower 2666 MHz JEDEC speed until the faster profile is enabled in the firmware.

How it compares

Measured against everything we stock in Cable Locks & Laptop Extras, at today’s prices. Recalculated every night.

Price $91.99
Pricier than about 90% of the 8,808 comparable items (median $16.99).

Specifications

No published specifications for this item yet.

Questions about this item

Does my motherboard need a 288-pin DDR4 slot to use this BM8GKITD43200DT kit?

Yes, the kit uses 288-pin DDR4 DIMMs that require a matching DDR4 slot on a desktop motherboard.

Will the two 4 GB modules run at their rated 3200 MHz speed if I keep my existing DDR4-2666 memory installed?

The system will downclock all modules to the lowest common speed, so the new kit will operate at 2666 MHz alongside the older memory.

How can I confirm the kit is running at 3200 MHz after installation?

Check the memory speed reported in the BIOS or a tool such as CPU-Z; it should show 3200 MHz (PC4-25600) when XMP is enabled.

More in Cable Locks & Laptop Extras

Similar items