BUCIER 10 Pin Motherboard Header to Dual USB 2.0 Female Adapter Cable 50cm

Internal USB 2.0 header expansion

This adapter converts a single 10 pin motherboard header into two standard USB 2.0 Type A female ports. It is intended for builders who need additional front panel or internal USB connections without using rear I/O slots. The 50cm cable length suits typical chassis routing from the motherboard to front drive bays or custom panels. The product is new and uses bare copper conductors.

Signal integrity over the 50cm run

The cable uses 28+28AWG bare copper wire to carry USB 2.0 signals between the header and the two Type A jacks. This gauge is chosen to maintain reliable data transfer across the full length under sustained peripheral use. No active circuitry is present so performance depends on the host controller and the quality of the connected devices. The adapter simply extends the existing bus without adding latency or bandwidth overhead.

Copper construction and dual port layout

The housing presents two USB Type A female sockets side by side, each wired from the single 10 pin header connector. Copper conductors provide durability for repeated plug cycles in daily use. The 50cm length offers enough slack for tidy cable management behind a motherboard tray or along a drive cage. Builders who require more than two additional ports or a different header pinout will need a separate solution.