SAMSUNG Atlas Sound AT-100 100W Commercial Attenuator video accessory
- Hard Wire Dimmer
- Black
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Replacement lithium-ion battery for Razor RipStik GR2247 and RS2202 boards, 22.2V 3.4Ah capacity
This lithium-ion pack is built for the Razor RipStik Electric Caster Board models GR2247 and RS2202. It delivers a nominal 22.2V and 3.4Ah capacity, matching the original equipment specification. The black casing fits the existing battery compartment without modification. Riders who need a direct swap for a depleted pack will find this unit ready to install.
The pack replaces the factory-fitted battery when runtime has dropped below usable levels. A jump is worth it when the board no longer holds a charge for a full session or shows voltage sag under acceleration. It restores the original 75.48Wh energy rating rather than increasing it. Buyers who want more storage than the stock 3400mAh design provides will need a different solution.
Under continuous draw the lithium-ion chemistry maintains a steadier voltage curve than aged nickel-based packs. The 22.2V output supports consistent motor torque across the discharge cycle. Heat buildup stays within the cell rating during extended runs. Users who regularly drain the pack to empty in one outing will see the same cycle-life limits as any lithium-ion pack of this capacity.
Measured against everything we stock in AV Accessories & Components, at today’s prices. Recalculated every night.
| Product | |
|---|---|
| Brand name | Cameron Sino |
| Model name | DS-CS-REG224XL |
| Product type | Home Electronics Battery |
Yes, the pack measures 124.20 x 76.80 x 22.80 mm and is built to match the original GR2247 and RS2202 housings used on the RipStik Electric Caster Board.
Slide the 22.2 V 3.4 Ah pack into the board's battery bay, reconnect the original wiring harness, and secure the latch; the step users skip is fully seating the connector until it clicks.
Replace it when run time drops well below the original 75.48 Wh rating or the board no longer holds a charge after a full cycle.
More in AV Accessories & Components
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?