Canon LVLP18 Projector Lamp 200W 2000 Hrs

Ready-to-install module

This Canon LVLP18 projector lamp ships as a fully assembled bulb and housing, so you can swap it into a compatible Canon projector without extra assembly. It is built for users who need a direct replacement that restores original brightness right away. The lamp uses a UHP light source rated at 200W and 2,000 hours of expected life. It suits classrooms, meeting rooms and home cinema setups that rely on consistent output.

Standard operation

In normal use the 200W UHP bulb runs at its rated power, delivering steady illumination for the full 2,000-hour span. Each unit is tested for ignition reliability, voltage stability and beam performance under ISO9001 controls before it leaves the factory. The housing design matches the original projector thermal path, keeping operating noise at the level the projector was engineered for. No additional cooling or power provision is required beyond the projector’s own supply.

Extended sessions

During long presentations or movie marathons the lamp maintains its rated output without the brightness drop-off seen in untested alternatives. Quality checks cover sustained run-time, so the module continues to ignite cleanly and hold voltage through repeated heating cycles. The 2,000-hour rating reflects continuous operation, not a short-burst figure, giving predictable replacement planning. Buyers who need a longer-rated lamp or a different wattage should look for another model.