Replacement Projector Lamps and Bulbs

Model code, wattage and bulb or full module

Match the lamp code or the projector model exactly, since lamps from one maker differ in wattage, shape and connector. A lamp for one model may not fit the next one up. Lamps are sold as a bare bulb or as a module with a housing. The housing simplifies fitting and protects the glass during installation, whereas a bare bulb must be seated into your old housing. Wattage in the listing is part of the match, not a bonus. The lamp inside is usually a high-pressure arc type such as UHP or NSH.

Lamp life, eco mode and safe replacement

Quoted life is a range, often a shorter figure in normal mode and a longer one in economy mode, and it often describes when brightness has fallen to about half rather than when the bulb dies. Let the projector cool fully and unplug it before opening the lamp door. Never touch the glass with bare fingers, and handle used lamps with care, because they contain mercury. After fitting, reset the lamp timer in the menu so the projector reports hours correctly.

Questions about Replacement Projector Lamps and Bulbs

How do I know which lamp my projector uses?

Look for the lamp code in the manual or on the sticker inside the lamp door, then match it in the listing. If you only know the projector model, use the compatibility line and confirm the wattage.

Is an original-maker lamp or a compatible lamp the better fit?

Original-maker lamps match the projector's specification, while compatible modules vary in brightness and life. Either can fit; read the description for the burner type and housing, and keep the lamp timer in mind.

Why does my projector shut itself off after fitting a new lamp?

The lamp door switch may not be fully closed, the lamp may be seated badly, or the timer needs resetting. Make sure the lamp is fully pushed in and the cover is secure, then reset the lamp hours in the menu.