Canon 5322B001 projector lamp 245 Watt for LV-7490 LV-8320
- 245 W
- 3,000 (Normal) - 5,…
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Genuine 340W Ushio NSH bulb in a pre-assembled housing delivers 2000 to 4000 hours of projection for the REALiS WUX6010
This replacement lamp module is built for Canon REALiS WUX6010 projectors and ships as a complete housing with a new 340W NSH bulb installed. It is intended for venues, classrooms or home cinema setups that need a direct, ready-to-fit light source without separate bulb handling.
The unit arrives fully assembled so installation is a single step; no alignment of a bare burner is required. Each module is produced to ISO9001 quality checks covering beam performance, ignition, voltage, connections and run-time, and the housing fits the projector's existing mount points exactly.
Verify that your projector is the REALiS WUX6010 model and that the existing lamp uses a 340W NSH burner rated for 2000 to 4000 hours of service life. This module replaces the Canon RS-LP09 part number only; other REALiS models or third-party housings will not match the electrical or mechanical interface.
Measured against everything we stock in Replacement Projector Bulbs, at today’s prices. Recalculated every night.
| Product | |
|---|---|
| Brand name | Canon |
| Product type | NSH |
| Display | |
| Lamp lifespan | 2000–4,000 h |
| Power | |
| Power rating | 340 W |
Yes, the RS-LP09 module ships with a new Ushio NSH 340 W bulb already installed in its housing, so the projector receives the specified 340 W output without any extra assembly.
The module is built to the original Canon RS-LP09 dimensions, so the housing slides into the WUX6010 lamp cage and the connector seats directly without adapters or modifications.
Power off and cool the projector, remove the lamp cover, release the retaining screws, pull the old module straight out, insert the new RS-LP09 until the connector clicks, re-tighten the screws, replace the cover, then reset the lamp timer in the menu — skipping the timer reset is the most frequent mistake.
More in Replacement Projector Bulbs
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?