We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Cleveland C24265 taper pin reamer number 10, 37/64 inch, bright straight finish

Cleveland

Cleveland C24265 Taper Pin Reamer No 10 37/64 in

SKU CH-8Q9D-67ZNR

A taper pin reamer sized No 10 with a 37/64 in cutting diameter for straight hole finishing

  • Product typeReamers
  • Precise hole sizing with No 10 taper specification
  • Accurate 37/64 inch diameter for standard pins
  • Straight flute design enables smooth material removal
  • Bright finish resists corrosion during extended use
  • Cleveland brand trusted for professional tool reliability

Cleveland C24265 Taper Pin Reamer No 10

This Cleveland C24265 is a straight taper pin reamer designated No 10 with a 37/64 in cutting diameter. It is a power and pneumatic accessory built for machine shops and maintenance technicians who need to size tapered holes for standard pins.

Bright finish straight flute performance

The bright finish on the straight flutes reduces material adhesion during extended cutting passes in steel or cast iron. Chip evacuation remains consistent because the straight geometry does not pull chips deeper into the hole under sustained feed pressure.

Straight shank fits standard holders

The straight shank seats directly in drill chucks, collets or floating holders without adapters. Misalignment between the reamer axis and the pre-drilled hole is the common cause of oversize or bell-mouthed tapers.

How it compares

Measured against everything we stock in Bits, Hole Saws & Accessory Kits, at today’s prices. Recalculated every night.

Price $137.99
Pricier than about 90% of the 5,493 comparable items (median $27.99).

Specifications

Product
Brand nameCLEVELAND
Product typeReamers

Questions about this item

How much heat does the No 10 reamer generate during extended hand reaming sessions?

The straight-flute 37/64 in tool cuts with minimal friction when used with cutting fluid, so heat build-up stays low even during repetitive taper-pin work.

What tap or pilot hole must I already have drilled before using this 37/64 in reamer?

A correctly sized pilot hole matching the small end of the No 10 taper is required; the reamer then finishes the full 37/64 in diameter along the taper length.

Will the C24265 reamer fit the Morse taper sockets on my older drill press?

The reamer has a straight shank, not a Morse taper, so it mounts in a standard drill chuck or collet rather than directly into vintage taper sockets.

More in Bits, Hole Saws & Accessory Kits

Similar items