We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Square M2 high-speed steel tool bit, 3/16 inch section, 2 1/2 inches long

Cleveland Golf

Cleveland Golf C44509 Square Tool Bit M2 3/16 In

SKU CH-TA7C-EBYZP

Square M2 high-speed steel tool bit, 3/16 in, for lathe work

  • Product typeHole, Drill, Bore & Wire Gauges
  • M2 high-speed steel resists wear
  • Square 3/16 in profile fits standard holders
  • 2 1/2 in length suits lathe work
  • Right and left hand use adds versatility

M2 High-Speed Steel Square Tool Bit

This square tool bit is made from M2 high-speed steel for lathe work and general machining. It measures 3/16 inch in both width and height with an overall length of 2 1/2 inches. The non-beveled blank suits right-hand and left-hand operations. Machinists and hobbyists shaping metal on a lathe will find it a practical addition to their tooling.

Thermals Noise and Power Draw

As a passive hand tool it generates no heat, produces no noise and draws no power during use. Performance depends entirely on the lathe setup and cutting parameters chosen by the operator. There are no thermal limits, acoustic ratings or electrical requirements to consider. Buyers needing powered cutting equipment should look elsewhere.

How it compares

Measured against everything we stock in Utility & Specialty Hand Tools, at today’s prices. Recalculated every night.

Price $7.99
Cheaper than about 87% of the 2,474 comparable items (median $23.99).

Specifications

Product
Brand nameCleveland
Product typeHole, Drill, Bore & Wire Gauges

Questions about this item

How do I install the 3/16 in square M2 tool bit in my lathe tool holder, and what step is often missed?

Insert the 2 1/2 in blank fully into the holder so the square faces seat flat, then tighten the clamp screws evenly; the step often missed is verifying the non-beveled edges sit flush before locking.

What maintenance will the M2 high-speed steel bit need after repeated use on steel workpieces?

Re-sharpen the cutting edges on a bench grinder using light passes to avoid overheating the M2 steel, then hone lightly to restore a keen edge.

More in Utility & Specialty Hand Tools

Similar items