We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Cleveland Golf cobalt drill bit 21/64 inch straw bronze finish parabolic flute 135 degree point

Cleveland Golf

Cleveland Golf Jobber Drill 21/64 Cobalt Parabolic 135° 2075

SKU CH-02ED-GJ7DX

Cobalt steel jobber drill with a 135° notch point and parabolic flutes for efficient chip removal in tough materials

  • Product typeAngle, Pitch & Slope Locators
  • Drills hard metals with 135-degree notch point
  • Parabolic flutes clear chips from deep holes
  • Cobalt steel resists heat during extended use
  • 21/64 inch diameter matches fractional specifications
  • Straw bronze finish reduces friction and wear

Cleveland Golf Jobber Drill 21/64 Cobalt

This cobalt steel jobber drill bit handles high-performance drilling tasks in tough materials. The 135-degree notch point reduces walking and starts holes cleanly. Fractional sizing at 21/64 inch suits precise workshop requirements. Right-hand cutting direction matches standard drill chucks.

Parabolic flute upgrades standard twist geometry

Parabolic flutes evacuate chips faster than conventional twist drills, especially in deep holes. The straw bronze finish resists wear during extended use. Upgrade when standard bits overheat or clog in stainless steel or titanium alloys. High-performance grade justifies the step up for production runs.

Straight shank fits common three-jaw chucks

Shank diameter matches the 21/64 inch drill size for direct insertion without sleeves. Overall length of 4-5/8 inches and flute length of 3-5/16 inches reach standard depths. Cobalt steel hardens quickly if run dry; use cutting fluid to prevent premature dulling. Non-coolant-through design requires external lubrication.

How it compares

Measured against everything we stock in Utility & Specialty Hand Tools, at today’s prices. Recalculated every night.

Price $21.99
Typical for this category: the median of 2,474 items is $23.99.

Specifications

Product
Brand nameCleveland
Product typeAngle, Pitch & Slope Locators

Questions about this item

What chuck size is required for the 21/64 inch shank?

A chuck that opens to at least 21/64 inch (0.3281 decimal) is needed to hold the shank securely.

How do you install the cobalt parabolic drill bit without damaging the 135-degree notch point?

Insert the bit fully into the chuck, tighten evenly on the 21/64 shank, and start the hole at low RPM to centre the notch point before applying full pressure.

When should the 2075 jobber drill be replaced or resharpened?

Replace or resharpen when the 135-degree notch point shows visible wear, the parabolic flutes no longer clear chips, or the straw/bronze finish has discoloured from overheating.

More in Utility & Specialty Hand Tools

Similar items