CMPLE Dual IR Emitter Extender 3.5mm 10 Feet

Dual IR emitter kit for hidden AV gear

This dual-emitter cable plugs into a 3.5 mm jack on an IR repeater or automation controller and sends infrared commands to two pieces of equipment that are tucked away in a cabinet or another room. The 10 foot lead lets you reach components on different shelves without moving the control block. It is aimed at installers and homeowners who want reliable remote operation without line of sight.

Stick-on emitters with spare adhesive

Each emitter has a clear adhesive film pre-applied so you can press it directly onto the IR window of a set-top box, Blu-ray player or receiver. A second set of double-sided tape is included for repositioning or replacement if the original pad loses grip. The emitters blink only invisible infrared light, so they do not create visible distraction in a darkened theatre.

Simple plug-in installation, alignment matters

The mono mini plug inserts into any standard 3.5 mm IR output; no drivers or configuration are required. The most common issue is misalignment — the emitter must sit squarely over the device’s IR sensor or the signal will not register. Routing the thin cable behind furniture or through conduit is straightforward, but sharp bends near the plug should be avoided to prevent wire fatigue.