Computer Memory Solutions CM10246412800SODRL 8GB DDR3L 1600 Dell Inspiron 13 7359 memory upgrade

System-Specific SO-DIMM for Dell Inspiron 13 7359

This 8GB DDR3L module is built to match the exact electrical and mechanical requirements of the Dell Inspiron 13 (7359). It delivers a straightforward capacity increase for owners of that notebook who need more memory for everyday multitasking. The stick is validated for the platform, so installation proceeds without compatibility guesswork. Buyers who need ECC error correction or registered buffering should look elsewhere, as this module provides neither.

204-pin unbuffered design at 1.35V

The module uses a standard 204-pin SO-DIMM edge connector and operates at the low-voltage 1.35V level defined for DDR3L. No heat spreader is fitted, keeping the profile thin enough for tight notebook slots. A single stick is supplied, so dual-channel operation is not possible unless a second identical module occupies the only other slot. The system maximum is 16GB, and a 64-bit operating system is required to address the full amount.

CL11 timing at 1600MHz with major-brand chips

Rated at DDR3-12800 (1600MHz) with 11-11-11 latency, the memory runs at standard JEDEC voltage and timing, drawing minimal power and producing no audible noise. Major-brand chipsets are used to maintain stability across the supported temperature range. The unbuffered, non-ECC design adds no overhead, so the notebook's memory controller manages refresh cycles directly. No active cooling or extra clearance is needed beyond the factory socket.