Crucial CT2K8G3S160BM 16GB (2 x 8GB) DDR3 1600 SO-DIMM memory upgrade
- 16 GB (2 × 8 GB)
- DDR3 1600
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
64GB kit of four 16GB DDR4 2133MHz ECC registered DIMMs for Dell PowerEdge R730, R730xd and T630 servers
This 64GB kit contains four 16GB DDR4 registered DIMMs validated for Dell PowerEdge R730, R730xd and T630 servers. The modules run at 2133MHz with CL15 timing at 1.2V and use a 2Rx4 organisation. ECC and register buffering provide the error correction and signal integrity required by these platforms.
The kit suits administrators expanding memory in the listed PowerEdge models up to the 384GB registered ECC limit or the 768GB load-reduced ceiling. It is not for workstations or desktops that accept only unbuffered non-ECC memory, nor for systems that cannot mix 2Rx4 modules within the same bank.
Registered buffering reduces electrical load on the memory controller during continuous operation, while ECC corrects single-bit errors that accumulate over long runtimes. The 1.2V DDR4 voltage keeps power draw predictable across fully populated configurations of 12 sockets per CPU or 24 sockets in dual-CPU deployments.
Measured against everything we stock in Model-Specific Memory Upgrades, at today’s prices. Recalculated every night.
New to this? Buying memory and SSDs with crypto — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | Computer Memory Solutions |
| Model name | CM2048722133ECCREG |
| Total capacity | 64 GB (16 × 4 GB) |
| Product type | 288-Pin DDR4 SDRAM |
| Performance | |
| Rated speed | DDR4 2133 (PC4 17000) |
| Processor | |
| Chipset | Major Brand Chipset |
| Memory | |
| CAS latency | CL15 |
| Memory timings | 15-15-15 |
| ECC support | Yes |
| Buffer type | Registered |
| Memory rank | 2Rx4 |
| Heat spreader | No |
| Power | |
| Rated voltage | 1.2 V |
| Compatibility | |
| Compatible systems | Dell Poweredge R730, Poweredge R730xd, Poweredge T630 |
| In the box | |
| Included items | 4 Memory RAM Sticks |
The kit is validated for the R730xd and installs directly into the 288-pin DDR4 slots; the server must already support registered ECC memory and you should not mix registered and unbuffered ECC modules in the same bank.
Mixing registered and unbuffered ECC memory is not supported in the PowerEdge R730, R730xd or T630, so the older unbuffered sticks must be removed before installing this registered kit.
Enter the BIOS or iDRAC interface and verify the memory configuration shows 64 GB total, 2133 MT/s speed, registered ECC mode enabled and no memory errors reported.
More in Model-Specific Memory Upgrades
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?