DELL 9TMRF PowerEdge R630 1100W 80 Plus Platinum Hot Swap Power Supply

Dell PowerEdge R630 power supply

This 1100-watt module delivers redundant hot-swap power for Dell PowerEdge R630 servers. It accepts 100 to 240 volts at 50 or 60 hertz and meets 80 Plus Platinum efficiency above 90 percent. The unit is built for mission-critical environments where uptime depends on swappable, matched power modules.

1100-watt capacity and headroom

The supply provides up to 1100 watts for fully populated compute nodes, high-density memory configurations and multiple storage controllers. Redundant pairing lets each module share the load, so a single failure leaves the server running. Workloads that exceed the combined 1100-watt budget will require a higher-rated chassis or reduced component count.

Hot-swap redundancy limits

Hot-swap replacement works only inside compatible Dell PowerEdge chassis with matching backplane connectors and firmware support. The 100 to 240 volt input range covers global mains, but the module cannot operate outside that window or on DC sources. Efficiency stays above 90 percent at typical loads, dropping only at very light or peak draws.