LSI MegaRAID SAS 9361-8i LSI00417 12Gb/s RAID controller
- Low Profile
- LSI00417
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
A RAID controller with 512MB non-volatile cache supporting RAID 0, 1, 5, 6, 10, 50, 60 for up to 32 SAS or SATA drives via PCIe 2.0
The Dell PERC H710 is a hardware RAID controller card built around the LSI SAS 2208 dual-core PowerPC ROC. It delivers 512 MB of non-volatile cache and supports RAID levels 0, 1, 5, 6, 10, 50 and 60 across SAS and SATA drives. The card targets servers and workstations that need protected, high-throughput internal storage arrays.
The controller installs in an eight-lane PCI Express 2.0 slot and presents two internal mini-SAS SFF-8087 connectors for cabling to backplanes or drive cages. A single card can manage up to 32 SAS or SATA devices, so cable routing and enclosure space become the practical limits rather than the controller itself. The PCIe 2.0 interface sets the host bandwidth ceiling for sustained array traffic.
Moving from a basic HBA or software RAID adds dedicated parity calculation, battery-backed cache protection and support for RAID 6, 50 and 60. The jump is worthwhile when workloads demand redundancy beyond mirroring, consistent write latency under load or the ability to span large drive counts without host CPU overhead. Systems limited to PCIe 1.x slots or lacking internal mini-SAS cabling cannot use this card.
Measured against everything we stock in RAID & Drive Controller Cards, at today’s prices. Recalculated every night.
New to this? Paying with USDT: TRC-20 or ERC-20 — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
The controller uses a 6.0 Gbps SAS link, so each attached drive is limited to that transfer rate.
It requires an 8-lane PCI Express 2.0 slot and uses two internal mini-SAS SFF-8087 connectors for drive cables.
Insert the card into an 8-lane PCIe 2.0 slot, connect the two mini-SAS cables, then enable the controller in the server BIOS before creating arrays.
More in RAID & Drive Controller Cards
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?