DIYMAG Magnetic Hooks 50 lbs Black 12 Pack

Heavy-duty holding for metal surfaces

These magnetic hooks use neodymium magnets with a 0.78 inch steel base to hold up to 50 lbs vertically on ferrous surfaces. The 12-pack supplies enough units for organising tools, lights or accessories in a workshop, garage, kitchen or on a cruise ship cabin. No drilling or adhesive is required, so installation and removal leave no residue. The nickel-copper-nickel coating resists rust for long-term indoor or outdoor use.

Replaces screws, nails and adhesive hangers

Switching to these hooks is worthwhile when you need strong, repositionable attachment points on steel beams, refrigerators or metal shelving without permanent holes. They are not suited for non-magnetic walls such as drywall, plaster, brick or wood unless a ferrous mounting plate is added. The pull rating applies to vertical shear on clean, flat iron or steel; paint, uneven surfaces or side loads will reduce effective strength.

Sustained load on vertical steel

Under continuous vertical weight the neodymium magnet maintains its rated hold as long as the contact surface stays clean, flat and free of rust or thick coatings. The triple-layer plating protects the magnet itself from corrosion during extended outdoor exposure. Shear forces, vibration or lever-arm loads from long-handled tools will lower the practical capacity below the 50 lb vertical figure.