Panasonic BK-3MCCA8BA Eneloop AA 2000mAh 2100 Cycle 8 Pack
- 8-pack
- AA Ni-MH
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
12.8 V LiFePO4 pack with 3300 mAh capacity, built-in 7 A protection PCB and 18 AWG leads, rated for over 1000 cycles
This DUSLAN 12.8 V LiFePO4 pack delivers 3300 mAh (42 Wh) in a four-cell 26650 layout. It suits builders who need a lightweight, long-cycle 12 V source for portable instruments, solar storage or UPS backup where safety and thermal stability matter. Buyers needing higher capacity or faster charge rates should look elsewhere.
The pack ships with 6-inch 18 AWG open-end leads for direct soldering or connector crimping. No holder or mounting hardware is included, so mechanical fixing is the installer's responsibility. A 7 A polyswitch and on-board PCB limit discharge and guard against over-charge above 15.6 V, over-discharge and short circuits, but the 1.5 A recommended charge current must be observed to avoid tripping protection.
At 3300 mAh the pack runs modest loads such as sensors, small radios or LED lighting for many hours; continuous draw is capped at 7 A by the protection circuit. Cycle life exceeds 1000 cycles at 80 % capacity retention (0.2 C, IEC). Peak voltage reaches 14.6 V and cut-off sits at 10 V, so equipment must tolerate this window.
Measured against everything we stock in Household Batteries & Chargers, at today’s prices. Recalculated every night.
| Power | |
|---|---|
| Battery type | Battery Pack |
Measure the open-circuit voltage with a multimeter; a healthy pack reads near 12.8 V and should not exceed 14.6 V when fully charged or drop below 10 V under load.
The pack arrives pre-wired with 6-inch 18 AWG open-end leads for charging and discharging; you will need a compatible LiFePO4 charger and any connectors or enclosures your project requires.
This model is offered only as a 3300 mAh (42 Wh) pack built from four 26650 cells; select it when you need roughly 42 Wh at 12.8 V with a 7 A discharge limit.
More in Household Batteries & Chargers
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?