Panasonic BK-3MCCA8BA Eneloop AA 2000mAh 2100 Cycle 8 Pack
- 8-pack
- AA Ni-MH
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Pack of twelve AA NiMH cells rated at 1800 mAh with solder tabs for direct wiring
This 12-pack supplies twelve AA nickel-metal-hydride cells rated at 1800 mAh each. They arrive with solder tabs on both ends for direct wiring into battery packs or custom electronics. The chemistry delivers a nominal 1.2 volt output and exhibits no memory effect. Each cell measures 49 mm long by 14 mm in diameter and weighs 29 grams.
The 1800 mAh rating is the single figure that determines whether these cells meet the energy budget of a given device. A higher-drain application will deplete them faster, while a lower-drain circuit will run longer on the same charge. Buyers who need more runtime per cell must select a higher-capacity AA model, as this pack does not offer greater capacity. The tabs enable series or parallel connections to match voltage and capacity requirements.
Under sustained cycling the cells are rated for up to 1000 recharge cycles before capacity drops significantly. This cycle life assumes normal charge currents and operating temperatures rather than rapid bursts or extreme loads. The nickel-metal-hydride chemistry maintains stable voltage through most of each discharge, then falls off near the end. Long-term reliability depends on avoiding deep over-discharge and storing the cells at partial charge when not in use.
Measured against everything we stock in Household Batteries & Chargers, at today’s prices. Recalculated every night.
| Power | |
|---|---|
| Battery type | AA |
The 1800 mAh rating indicates the cell can supply 1800 milliamps for one hour; a device drawing 100 mA would run for roughly 18 hours before the voltage drops below usable level.
Most AA devices tolerate the lower 1.2 V of NiMH chemistry, but some high-drain or voltage-sensitive gear may show reduced performance or shut down earlier than with fresh alkalines.
The tabs extend from each end of the 49 mm by 14 mm cell, so they will not fit a regular spring-loaded holder; they are designed for direct soldering into a pack or onto a PCB.
More in Household Batteries & Chargers
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?