Panasonic BK-3MCCA8BA Eneloop AA 2000mAh 2100 Cycle 8 Pack
- 8-pack
- AA Ni-MH
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Twelve 1/2 AA lithium thionyl chloride cells deliver 3.6 volts and 1200 mAh for backup power, meters and industrial equipment
This pack supplies twelve primary lithium thionyl chloride batteries in the 1/2 AA form factor. Each cell delivers a nominal 3.6 V and 1200 mAh capacity. They suit equipment that requires long-term, low-current power such as utility meters, medical devices, telecom modules and LED lighting. The wide operating range from -55 °C to +85 °C supports harsh environments.
The lithium thionyl chloride chemistry is strictly primary; recharging attempts are unsafe and will damage the cells. A nominal voltage of 3.6 V at 1 mA load and an open-circuit voltage of 3.66 V are specified. Storage should not exceed +30 °C in a clean, dry, ventilated area to preserve shelf life.
The supplier lists direct replacements for numerous Tadiran, Saft, Toshiba, Sonnenschein and generic part numbers including TL-5902, LS-14250, ER3v and SL-350/S. This compatibility eases sourcing for legacy designs without requiring circuit changes. No tabs, soldering hardware or software are bundled.
Measured against everything we stock in Household Batteries & Chargers, at today’s prices. Recalculated every night.
| Power | |
|---|---|
| Battery type | 1/2 AA Lithium |
The 1200 mAh rating means the cell can supply 1 milliampere for about 1200 hours, or 100 mA for roughly 12 hours, before voltage drops below usable levels. Actual runtime depends on the load profile of your meter, sensor or backup circuit.
At a 1 mA drain the cell holds 3.6 V; open-circuit it reads 3.66 V. Higher currents pull the voltage down, so verify your circuit's minimum operating voltage before relying on the full capacity.
Yes. The maximum diameter is 14.5 mm and maximum height is 25.25 mm, matching the 1/2 AA form factor used in most PCB holders, meter compartments and slim camera battery bays.
More in Household Batteries & Chargers
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?