DUSLAN 9.6V LiFePO4 Battery Pack 6400 mAh with Leads

9.6V LiFePO4 Pack for Custom Power Projects

This 9.6 volt lithium iron phosphate battery pack delivers 6400 mAh capacity and 62 Wh energy through pre-wired 18 AWG leads. Six 26650 cells in a 2 x 3 arrangement provide a compact 7.9 by 2.1 by 1.2 inch form factor weighing 1.2 lbs. The integrated PCB limits charge and discharge current to 2 amp while protecting against over-charge above 11.7 volt, over-discharge and short circuits. UN 38.3 certification confirms transport safety for this new pack.

Suits Portable Devices Needing Stable 9.6V Supply

Builders powering robotics, test equipment or RC platforms that operate between 7.5 and 11.4 volt will appreciate the flat discharge curve and over 1000 cycle life at 0.2C rate. The hard-wired leads simplify permanent installation but prevent hot-swap use. Applications requiring more than 2 amp continuous current, higher voltage rails or user-replaceable cells should consider alternative configurations.

6400 mAh Handles Moderate Loads With Ample Headroom

At the rated 2 amp limit the pack supplies roughly three hours of runtime before reaching the 7.5 volt cut-off. The 62 Wh capacity supports intermittent higher bursts within PCB limits while the LiFePO4 chemistry maintains performance across a wide temperature range. Extended high-drain sessions exceeding the 2 amp protection threshold will trigger shutdown, so size the load accordingly.