Premier Mounts PDS-PLUS-W ceiling projector mount
- Ceiling Mount
- Projector
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Replacement projector lamp compatible with Hitachi CP-A and ED-A series models including CP-A220N, CP-A250NL and CP-AW250NM
The DT01381 replacement lamp fits Hitachi CP-A220N CP-A221N CP-A250NL CP-A300N CP-A301N CP-AW250NM CP-AW251N ED-A220NM and iPJ-AW250NM projectors. It serves as a direct substitute for the original lamp module in these specific units. The lamp is also cross-referenced with part numbers DT01251 CPAW250NLAMP and CPA222WNLAMP for easier identification.
This lamp ships with an economy bulb installed to reduce the upfront cost of restoring projector brightness. The economy option provides functional illumination for presentations and classroom use while keeping replacement expenses lower than premium alternatives. No additional software or accessories are included in the package beyond the lamp assembly itself.
Before ordering confirm that your Hitachi projector model appears in the supported list above. The lamp will not fit models outside this range even if they share similar naming conventions. Check the exact model label on your device to avoid a mismatch that would prevent installation.
Measured against everything we stock in Projector Mounts & Add-Ons, at today’s prices. Recalculated every night.
| Product | |
|---|---|
| Product type | Projector Lamp |
The DT01381 lamp is a consumable part; replacement timing depends on the projector's usage hours and brightness settings, with no fixed interval stated.
The lamp's rated life and thermal design set the practical limit; sustained use will eventually require a fresh DT01381 module.
It is built to match the original specifications for the CP-A221N and other listed models, so heat and noise should be equivalent.
More in Projector Mounts & Add-Ons
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?