eForChina 5.5 x 2.1mm DC Power Gender Changer 1m Black
A 1-metre DC power extension cable with 5.5 mm × 2.1 mm female-to-male connectors for secure, easy cabling
- Adapter typePower Adapter
- Easy installation saves setup time
- Secure cable connection prevents accidental disconnects
- 5mm x 2.1mm DC power jack female to male connector
- TPE, PVC and metal construction for durable cabling
- 1m cable length suits desktop power arrangements
1m DC Power Extension Cable
This 1 metre DC power extension cable uses a 5.5mm x 2.1mm male-to-female barrel connector to lengthen existing power leads. It suits builders who need to bridge a short gap between a power supply and a device. Buyers requiring a different barrel diameter or a locking connector will not find a match here.
TPE Jacket Handles Routine Bending
The cable sheath combines TPE and PVC over metal contacts to maintain a secure connection during repeated insertion cycles. It is designed for standard indoor routing where the lead lies flat or follows gentle curves. Installations subject to tight bends, continuous flexing or outdoor exposure fall outside its intended use.
Fixed 5.5 x 2.1mm Interface Limits Compatibility
The barrel connector adheres to the common 5.5mm outer and 2.1mm inner diameter, so it only mates with matching jacks. Polarity follows the usual centre-positive convention but is not mechanically keyed, so verifying the device requirement remains essential. Adapters for other barrel sizes or screw-terminal blocks are not included.
How it compares
Measured against everything we stock in Other Adapters & Couplers, at today’s prices. Recalculated every night.
- Price $5.99
- Cheaper than about 92% of the 1,761 comparable items (median $18.99).
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
| Product | |
|---|---|
| Adapter type | Power Adapter |
Questions about this item
Does the 1 m cable add noticeable resistance when my 5.5 x 2.1 mm adapter runs continuously?
The 1 m length uses TPE+PVC conductors rated for 8 A, so voltage drop under continuous load stays minimal for typical DC devices.
What must I already have so the female jack accepts my power brick?
Your existing supply needs a 5.5 mm outer diameter and 2.1 mm centre pin male plug to mate with the female connector.
Will the male end fit the 5.5 x 2.1 mm input on my older router?
Yes, the male plug matches the 5.5 mm by 2.1 mm barrel size used on many legacy routers and similar gear.
More in Other Adapters & Couplers
Similar items
TeKit NTRC100223W HDMI Female to DVI Male Adapter 24+1
- HDMI Female to DVI…
- Black
Cables To Go 03411 Two Port Keystone Single Gang Wall Plate White
- White
- With a wide selecti…
TeKit USB 2.0 A Female to Micro USB Female Adapter 2 Pack
- USB A Male to Micro…
- Black
Monoprice Inc. 8729 S/PDIF Toslink gender changer White
- White
TeKit IEC C13 Right-Angle Adapter 250V 10A 16A Black
- IEC320 C13 Female P…
- Black





