ESTONE TJ-A022 DisplayPort cable 100 ft 32.4 Gbps 8K@60Hz 4K@144Hz

100 ft fibre DisplayPort cable

This 100 ft optical DisplayPort cable carries 8K at 60 Hz or 4K at 144 Hz over a single male-to-male link. It is built for installers and enthusiasts who need a permanent in-wall run between a source and a display without repeaters. The hybrid glass-fibre and copper construction keeps the signal intact at distances where copper cables fail. Directional connectors mean the source and display ends must be matched correctly during installation.

32.4 Gbps bandwidth headroom

The link delivers up to 32.4 Gbps, enough for 7680×4320 at 60 Hz and 4K at 144 Hz while remaining backward compatible with 2K and 1080P timings. Four optical fibres isolate high-frequency TMDS lanes from each other, preventing crosstalk that limits copper at this length. The cable runs out of headroom only when the source or sink cannot generate or accept the target resolution and refresh rate. No external power is required because the optical engines draw from the DisplayPort pins.

24K gold connectors and TPE jacket

Gold-plated DisplayPort 1.4 plugs resist oxidation through years of mate cycles in a fixed installation. The wear-resistant TPE outer jacket protects the fibre cores during pulling through conduit or trunking. A single connector at each end keeps the profile slim for tight bends behind walls. The directional labelling on each plug removes guesswork when terminating the run.