We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Four tiny green circuit boards with soldered components

GCON

GCON PW-D Buck Converter 6-24V to 5V 1.5A 4pcs

SKU CH-6H6P-PKVVZ

Four buck-converter modules step 6–24 V down to 5 V at 1.5 A in a 17 × 5.5 mm footprint for 2-6S battery-powered transmitters, receivers or mini cameras

  • Powers transmitters, receivers or mini cameras from 2-6S batteries
  • Steps 6-24V input down to a stable 5V 1.5A output
  • Ultra-compact 17mm by 5.5mm footprint fits tight builds
  • Four modules included for multiple devices or spares
  • Designed specifically for 2-6S battery voltage ranges

Four-Module Step-Down Pack

This pack contains four identical PW-D buck converters that accept a 6-24V input and deliver a regulated 5V output at up to 1.5A. They are intended for hobbyists and builders who need to power small 5V devices such as video transmitters, receivers or miniature cameras from a higher-voltage source.

Efficient Low-Power Operation

Each module uses a compact switching topology that steps voltage down with minimal heat when supplying typical transmitter or camera loads. The tiny 17mm by 5.5mm footprint leaves almost no thermal mass, so sustained current near the 1.5A limit will warm the board noticeably; airflow or a heat-spreader helps in enclosed installations.

Simple Integration For Battery Builds

The pin spacing suits direct soldering to 2-6S battery packs or existing 5V rails, and the miniature outline fits inside tight frames such as micro drones or handheld gimbals. No additional capacitors or inductors are required, freeing layout space and keeping the bill of materials short for compact 5V sub-systems.

How it compares

Measured against everything we stock in Other Adapters & Couplers, at today’s prices. Recalculated every night.

Price $20.99
Pricier than about 60% of the 1,761 comparable items (median $18.99).

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Specifications

No published specifications for this item yet.

Questions about this item

How do I wire the PW-D buck converter into my 2-6S battery pack without reversing the polarity?

Connect the battery positive to the 6-24V input pin and negative to ground, then take 5V and ground out to your transmitter or mini camera; the 17 mm by 5.5 mm board leaves little room for error, so double-check polarity before soldering.

What component is most likely to need replacement after extended use with a 24 V input?

The onboard switching regulator handles the step-down to 5 V at 1.5 A; sustained high input voltage increases thermal stress on this IC, so it is the part most likely to degrade first.

At what point does the 1.5 A current limit become the bottleneck during continuous operation?

The module is rated for 1.5 A output; if your transmitter, receiver or mini camera draws more than that, the converter will hit its current limit and shut down or overheat.

More in Other Adapters & Couplers

Similar items