Athena Power AP-P4ATX60FE 600W server power supply
- 600 W
- Single
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
1400W server power supply with breakout board and nine PCIe 6-pin to 6+2-pin cables, active PFC, 95-264V input, 95% condition
This kit bundles a 1400W server power supply with a breakout board and nine PCIe 6-pin to 6+2-pin cables. It delivers up to 1400W from a 95V to 264V input with active PFC. The unit is non-modular and carries an 80 PLUS certification listed as Other Certification. It targets builders who need high-density 12V power for GPU arrays in server or mining chassis.
The supply replaces 750W or 1200W server PSUs when the load exceeds their continuous rating. The jump is worth it when a single 12V rail must feed multiple high-draw GPUs without daisy-chaining external units. Buyers who need redundant hot-swap frames or ATX-form-factor mounting will not find those features here.
Each included cable converts a 6-pin connector to a 6+2-pin plug, capping per-connector delivery at the 6-pin specification. The nine cables support up to nine GPU auxiliary inputs, but total draw must stay within the 1400W rating. Systems requiring 12VHPWR or 12V-2x6 connectors cannot use this kit without adapters not included.
Measured against everything we stock in Server & Hot-Plug PSUs, at today’s prices. Recalculated every night.
New to this? Buying PC parts with Monero — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
The unit is a standard server PSU form factor; allow space for the rear exhaust fan and the breakout board cables that extend from the front edge.
Slide the breakout board onto the PSU's card-edge connector until it clicks, then tighten the two retention screws; the step most people skip is securing those screws, which can cause intermittent power under load.
Inspect the 9 cables regularly; replace any that show melted connectors, cracked insulation or loose pins, especially after sustained 1400 W mining loads.
More in Server & Hot-Plug PSUs
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?