Hakko T15 Conical Soldering Tip 0.2mm x 12.7mm

Conical Tip for Precision Soldering

The Hakko T15-IL conical tip measures 0.2 mm at the point and 12.7 mm in length. It fits Hakko FM-2027 and FM-2028 handpieces and works with FM-202, FM-203, FM-204, FM-206, FP-101, FP-102, FX-950 and FX-951 stations. The composite HAWA material withstands a maximum operating temperature of 840 degrees F. This tip targets technicians who need fine access on dense boards.

Upgrade from Worn or Broader Tips

Replace a flattened or oxidised conical tip when the point no longer wets cleanly or when a chisel profile is too wide for the joint. The 0.2 mm diameter reaches tight pads that broader geometries cannot touch. The jump is worth it when rework density increases or when the current tip forces excessive dwell time that risks component damage.

Behaviour Under Continuous Use

The HAWA composite maintains thermal stability during long sessions at the rated 840 degrees F limit. Heat recovery stays consistent across repeated joints without the rapid drop-off seen in worn tips. The narrow profile concentrates energy on small pads, so sustained loads on fine-pitch work remain controlled. Buyers needing high-mass thermal reservoirs for large planes should select a different geometry.