Canon 5322B001 projector lamp 245 Watt for LV-7490 LV-8320
- 245 W
- 3,000 (Normal) - 5,…
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
A ready-to-install 180 W replacement lamp module rated for 2,000 hours of operation
The CP-HX2175 is a complete replacement lamp assembly for compatible Hitachi projectors. It arrives with a new Philips UHB 180 W bulb already seated in its housing, so no separate bulb handling or alignment is required. Installation is a straightforward swap that restores full brightness in minutes.
Each unit is assembled to ISO 9001 standards using genuine Philips, Osram, Ushio, Phoenix, Iwasaki or Matsushita bulbs. The fixed housing ensures precise optical alignment and secure electrical connections every time. Rated lamp life is 2,000 hours under normal operating conditions.
This lamp fits projectors that specify the CP-HX2175 or DT00731 part number; other Hitachi models use different modules and will not accept it. Buyers who need a bare bulb without housing or a higher-wattage alternative should look for a different product. No tools beyond a screwdriver are typically required for the swap.
Measured against everything we stock in Replacement Projector Bulbs, at today’s prices. Recalculated every night.
| Product | |
|---|---|
| Product type | Projector Lamp |
| Display | |
| Lamp lifespan | 2,000 Hrs. |
| Power | |
| Power rating | 180 W |
The lamp uses the projector's proprietary socket; the 180W UHB bulb determines output and ignition requirements, not an external interface standard.
The pre-assembled housing mirrors the original DT00731 form factor, aligning with the projector's lamp cage rails and retaining screw positions.
Power off and cool the projector, remove the lamp cover, release the retaining screws, slide the module in until the connector seats, re-tighten screws, replace the cover, then reset the lamp timer in the menu.
More in Replacement Projector Bulbs
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?