Canon 5322B001 projector lamp 245 Watt for LV-7490 LV-8320
- 245 W
- 3,000 (Normal) - 5,…
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Replacement lamp module with Philips UHP 215W bulb, rated 5000 to 6000 hours, ready to install
This projector lamp module is built for the Hitachi CP-X3030WN and ships as a fully assembled bulb and housing unit. It uses a 215W Philips UHP bulb and matches the original DT01431 part number for immediate installation. Facility managers and AV technicians can swap the module without extra tools or alignment steps.
Each unit is produced to ISO 9001 standards and tested for beam performance, ignition voltage, connections and run-time before dispatch. The housing arrives complete, so the installer simply removes the old module and seats the new one in the same mounting points. Three OEM variants and a compatible version are offered depending on stock, all using genuine OEM components.
Confirm the projector is a CP-X3030WN and note the current lamp-hour counter to plan the changeover. The lamp is rated for 5000 hours in normal mode or 6000 hours in economy mode, so scheduling replacement around those intervals avoids unexpected downtime. Buyers needing a different wattage, a bare bulb without housing, or a lamp for another projector series should look elsewhere.
Measured against everything we stock in Replacement Projector Bulbs, at today’s prices. Recalculated every night.
| Product | |
|---|---|
| Product type | Projector Lamp |
| Display | |
| Lamp lifespan | 5,000 (Normal) - 6,000 (Economy) Hrs. |
| Power | |
| Power rating | 215 W |
Yes, the module is built around a Philips UHP 215 W bulb and plugs directly into the Hitachi CP-X3030WN socket, so the projector’s own driver caps the power at 215 W.
The pre-assembled housing matches the original DT01431 form factor and aligns with the projector’s two retaining screws and guide pins, needing no extra brackets or adapters.
Power off and unplug the projector, let it cool 30 minutes, remove the lamp cover, unscrew the old module, insert the new DT01431 unit, tighten both screws, replace the cover, then reset the lamp timer in the menu — the reset is the step users most often forget.
More in Replacement Projector Bulbs
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?