Hitachi, Ltd. CP-X401 220W Projector Lamp DT00841

Ready-to-install lamp module

This replacement lamp module fits the Hitachi CP-X401 projector and arrives as a complete assembly with a 220W Ushio UHB bulb already seated in its housing. The unit is manufactured to ISO9001 quality standards and tested for beam performance, ignition voltage, connections and run-time. It is intended for owners who need a direct, new lamp without sourcing a bare bulb separately. Buyers who require a bare bulb only or a different wattage should look elsewhere.

Drop-in replacement for CP-X401

The module slides into the projector’s lamp compartment without tools and draws the same 220W as the original lamp, so no electrical changes are needed. Because the bulb and housing are pre-assembled, installation time is reduced to a simple swap. The lamp is rated for 2,000 hours of operation under normal use. Installations that demand a different form factor or a higher-wattage light source cannot use this module.

Steady output over rated life

Under continuous operation the UHB bulb maintains consistent brightness and colour stability throughout its 2,000-hour rated lifespan. Quality checks verify reliable ignition and stable voltage from first strike to end of life. The design is built for sustained projection sessions rather than short intermittent bursts. Users who need a longer-rated lamp or a different bulb technology will not find those specifications here.