Canon 5322B001 projector lamp 245 Watt for LV-7490 LV-8320
- 245 W
- 3,000 (Normal) - 5,…
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Genuine 230 W replacement lamp module with 2,000-hour rated life for Hitachi projectors
This new Hitachi CPX445LAMP module delivers a fully assembled 230W UHB bulb inside its housing for immediate installation. It serves as a direct replacement for the original lamp in supported Hitachi projectors. The unit arrives ready to fit without extra assembly steps.
Swapping this module restores brightness when the factory lamp reaches its rated 2000-hour lifespan or shows dimming and colour shift. The upgrade is worth it when image quality drops below usable levels for presentations or classroom use. Each version supplied meets ISO9001 manufacturing standards for beam performance and run-time.
This lamp fits only projectors designed for the CPX445LAMP form factor and 230W electrical specification. It cannot be used in models requiring different wattages, connector layouts or housing dimensions. Buyers needing higher lumen output or longer rated life must select a projector that supports a different lamp specification.
Measured against everything we stock in Replacement Projector Bulbs, at today’s prices. Recalculated every night.
| Product | |
|---|---|
| Product type | Projector Lamp |
| Display | |
| Lamp lifespan | 2,000 Hrs. |
| Power | |
| Power rating | 230 W |
The CPX445LAMP is designed for Hitachi projectors that specify this exact part number; check your projector manual or lamp door label for CPX445LAMP compatibility before ordering.
Power off and unplug the projector, allow full cool-down, remove the lamp cover, release the retaining screws, slide the old module out, insert the new CPX445LAMP until it seats firmly, re-tighten screws, replace the cover, then reset the lamp timer in the menu.
The lamp is rated for 2000 hours; replace it when the projector's lamp-hour counter approaches that figure or when image brightness drops noticeably.
More in Replacement Projector Bulbs
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?