Hubbell HBL320R4W 20A 125V IEC Receptacle Yellow
IEC 20 A 125 V receptacle with IP67 watertight thermoplastic housing and spring-loaded cap
- Color familyYellow
- Color and finishYellow
- Product typeLight Switch
- Watertight IP67 rating protects against dust and water ingress
- IEC grounding style meets international industrial wiring standards
- 20 A current rating supports heavy-duty equipment loads
- Spring-loaded cap seals the receptacle when not in use
- Yellow thermoplastic housing resists impact and chemicals
Industrial IEC Receptacle
The Hubbell HBL320R4W is a 20A 125V AC pin-and-sleeve receptacle built for industrial environments. It suits facilities that need a grounded, IP67-rated connection for single-phase equipment up to 1 hp.
Watertight Thermoplastic Housing
Yellow thermoplastic housing resists corrosion and impact while the spring-loaded cap seals the face when unmated. Flanged mounting with a 2.85 in face diameter allows direct panel installation, and the shrouded pins accept up to 10 AWG conductors.
Sealed for Wet Locations
IP67 and NEMA 4X ratings keep water and dust out of the contact area during wash-down or outdoor exposure. The grounded three-wire, two-pole design maintains circuit integrity without adding active cooling or power-draw concerns.
How it compares
Measured against everything we stock in Electrical Switches & Dimmers, at today’s prices. Recalculated every night.
- Price $120.99
- Pricier than about 79% of the 791 comparable items (median $39.99).
Specifications
| Product | |
|---|---|
| Brand name | HUBBELL |
| Color and finish | Yellow |
| Color family | Yellow |
| Product type | Light Switch |
Questions about this item
What does the IP67 rating on this 20 A receptacle mean for dust and water protection?
IP67 means the housing is dust-tight and can withstand temporary immersion in water under defined test conditions, suitable for wet industrial locations.
What flange size and mounting holes does the 2.85 in face diameter require?
The 2.85 in face diameter fits a standard single-gang flanged cut-out; mount with four screws through the flange holes onto a flat surface or approved enclosure.
How do I wire the 3-wire 10 AWG maximum conductors into the straight IEC pins?
Strip each conductor, insert fully into the corresponding straight pin terminal, tighten the terminal screws to the specified torque, then snap the spring-loaded cap shut.
More in Electrical Switches & Dimmers
Similar items
Leviton Manufacturing Co. 052-10097-008 pull chain switch
Schneider Electric 9001KR25RH6 push button 30 mm 1NC red
- Red
- Light Switch





