Hubbell Incorporated 02203038 Cable Support Grip Offset 0.63 to 0.74in

Cable Support Grip for 0.63 to 0.74in Cables

The Hubbell Wiring Device-Kellems 02203038 is an offset eye single weave cable support grip designed for cable diameters ranging from .63 to .74 inches. It suits installers who need reliable strain relief on vertical or horizontal cable runs. The transparent tin coated bronze mesh provides corrosion resistance while maintaining visibility of the cable condition. This grip is not intended for cables outside the stated diameter range or for applications requiring a straight eye configuration.

Tin Coated Bronze Mesh with CSA Certification

The grip uses tin coated bronze material that resists oxidation in damp or outdoor environments. Its single weave construction delivers a breaking strength of 750 lb while the mesh length of 9 in distributes load evenly along the cable jacket. CSA certification confirms compliance with Canadian safety standards for electrical installations. No additional hardware or software is bundled with this accessory.

Breaking Strength of 750 lb Determines Suitability

The 750 lb breaking strength is the critical specification that decides whether this grip matches the mechanical load of your installation. Heavier cable bundles or longer unsupported spans may exceed this rating and require a higher strength grip. The product weighs .17 units and has an overall length of 15.000 units. Verify the calculated tension against this figure before specifying the part.